Normal value of 35kV bus voltage

Voltage/BIL: 35 kV class, typical BIL 170 kV. Short-circuit: 25–40 kA short-time withstand common; confirm with system fault study. Continuous current: 1250–3150+ A bus and feeder options. Standards: IEC 62271-200; internal arc testing per IEC/TR 61641 if specified. The Insulation levels for Distribution, Class 1 and Class 2 transformers shall be selected from this table for both the high-voltage and low-voltage windings. All test levels are line to ground. The applied test levels are not applicable to wye-connected windings unless they have been specified to. PURPOSE: To provide general construction requirements for representative wood pole structures and assemblies for 34. 5 through 69 kV transmission lines. 2-1. Most distribution voltages are between 4 and 35 kV. In this article, unless otherwise specified, voltages are given as line-to-line voltages; this follows normal industry practice, but it is sometimes a source of confusion. A voltage class is. This article is for manufacturing, testing of non-segregated Bus Bars and Bus Ducts rated 600 V to 35 kV as per international standard ANSI C37. Air insulation with generous. Rated maximum voltage, kV BIL, kV Manufacturing Date: MM/YYYY Rated continuous current, A Rated load interrupting rating, A Momentary current rating, kA asym. Close & latch rating, kA asym. Liquid dielectric volume (gallons) – Liquid-Filled Units Only SF6 Weight, Pressure – SF6. [PDF]